AN-M30 BOMB Makes
December 20, 2022
This is a 200% version printed by Chris G. He did an amazing job with this make… He even printed a bomb cradle that he found on Cults3D to go along with it.
At 200% his make is over 20 inches long which makes it just about half scale compared to the real bomb.
He also did not glue on the nose cone which allows for storage inside the bomb. He also made his own latch and used magnets to keep it in place.
He also used magnets in the fuses so they would not be damaged with any improper handling.
Chris says he also glued extra weights inside the bomb so that it would balance correctly because the tail fins end up being heavy.
His nose fuse and arming wire.
Chris did an amazing job re creating this and I really appreciate his support and allowing me to sharing his make. Thanks again Chris….
All Information, Pictures, and Material is copyright © 2018 by Stephen Thone and may not be used for any personal or commercial purposes without the consent of the author. All rights reserved. The Author makes no guarantees or warranties as to the accuracy or completeness of, or results to be obtained from accessing and using the Information herein.