UFO Terrarium

UFO Terrarium

Invasion of the Botany Snatchers

This is a UFO Terrarium I designed in Solidworks, it was just another fun little project I designed for no other reason than the idea popped into my head.

The body and legs were printed in Silver eSun PLA and I found the dome on Amazon, it was a little expensive at $25 and I cracked it even before finishing the UFO but it was still usable.

The red light pieces were printed in PETG because I was going to run LEDs throughout the body to have it really light up but in the end I decided it was too much work.

Because of the size the body was design to be printed in four separate sections and then glued together. Over all it was a fun project but really was a little small to use as an actual Terrarium as the plants out grew it pretty quickly.

All Information, Pictures, and Material is copyright © 2018 by Stephen Thone and may not be used for any personal or commercial purposes without the consent of the author. All rights reserved. The Author makes no guarantees or warranties as to the accuracy or completeness of, or results to be obtained from accessing and using the Information herein.

2 Replies to “UFO Terrarium”

    1. I probably have them somewhere just drop me a direct email and I’ll see if I can round them up.

Leave a Reply

Your email address will not be published. Required fields are marked *