Twin Dog Fighter Spad
Twin Dog Fighter Spad
SPECIFICATIONS
- Wingspan: 48 in
- Wing Area: 432 sq in
- Fuselage Length: 24 in
- Motor: (2) O.S. .25FP’s
- Channels: 4 – Throttles, Ailerons, Elevator, Rudders
- Currant Status: Reconfigured/Retired?
I threw this plane together just to test out my 2 motors and to see if I could sync them before I build the C-119. I all ready had the fuselages built for a combat plane and just folded another wing up. It really didn’t fly to well, (or at all I should say) I think it was too heavy, it went about a hundred yard and the nose was at about 45 degrees and there wasn’t much I could do, it just wouldn’t climb out. I tried dropping the nose but it just wouldn’t go, so I decided to just put it in before it lost total control. One of the fuselages split on impact so I just hacked it up at the field and in about 15 minutes it was flying again as a single just to get some time on the newer engine.
Here’s the15 minute reconfigured single version.
Trimmed up rudder and Stab. I’m not sure what happened to this plane I think it got left behind during a move.
All Information, Pictures, and Material is copyright © 2022 by Stephen Thone and may not be used for any personal or commercial purposes without the consent of the author. All rights reserved. The Author makes no guarantees or warranties as to the accuracy or completeness of, or results to be obtained from accessing and using the Information herein.