September 19, 2109

3D Printed Deep Diver Crankbait

This is the design stage of a deep diving crankbait I am currently working on.

The 3 Views.  I’m not sure if it’s going to work yet I might have to change the lip design… some trial and error will be needed.

Printed and ready for assembly.

Initial testing went well, it swims straight at least. I don’t know how deep it dives yet as I was only able to test it from shore and the water was to murky to see. I may need to add a little more weight in the rear though just so it balances better.

Still needs proper testing but I threw some paint on it.

To be continued….

All Information, Pictures, and Material is copyright © 2019 by Stephen Thone and may not be used for any personal or commercial purposes without the consent of the author. All rights reserved. The Author makes no guarantees or warranties as to the accuracy or completeness of, or results to be obtained from accessing and using the Information herein.