Reloading Scale Check Weights

These are a simple set of check weights I turned from a piece of brass on the Mini Lathe. They were made just to check the constancy of the scale over time not to actually calibrate it.

At the time I made them I checked what they would weigh in grains on my scale and marked them accordingly.

When I need to check my scale in the future I can check with the weights to see if they still read the same.

I made a chart of different combinations to see how accurate the scale stays over time.

All Information, Pictures, and Material is copyright © 2018 by Stephen Thone and may not be used for any personal or commercial purposes without the consent of the author. All rights reserved. The Author makes no guarantees or warranties as to the accuracy or completeness of, or results to be obtained from accessing and using the Information herein.